Electropress Ltd are the sole agents for Alfra Products throughout UK & Ireland.
Our range of Alfra Machines are used for the construction of Control & Switchgear Panels but also used by Electricians - Electrical Contractors - Carpenters - & Plumbers.
Alfra electronic system ref 2420 is a 2 in one machine which can bend & punch through copper bus bar up to the size 120mm x 12mm - The range of punch and dies are from (standard) 6.6mm up to 21.5mm - non standard sizes can easily be supplied as well as square and elongated punch and dies. This machine also has an electronic angle cut out for very accurate repeat bending and can also be fitted with a digital angle selector if required as an extra item.
The change over from bending to punching takes only a few seconds by turning a switch located on the outer casing of the machine - a cutting tool stands at the side of the machine which can be connected also in a matter of seconds and this tool will cut through copper bus bar up to 12mm thick in 5 seconds leaving a clean edge without burrs
|
on the move, store contacts, email suppliers quickly, all from any device with an internet connection
here
to reveal number
